Clarity E814 User Manual page 25

4. Press <oK/menU> to confirm the setting; display shows Saved, you will hear a
beep; display goes back to the previous screen; press <cLear/mUte> to return
to previous menu.
note: The respective ringer melody will be played during your selection.
set the Dial mode
You should normally leave the dialling mode at its default setting of TONE (also called
DTMF) unless the phone is connected to an old exchange that only recognizes
PULSE dialling.
In Idle:
1. Press <oK/menU> and <UP/down> to select Settings.
2. Press <oK/menU> and <UP/down> to select Dial mode.
3. Press <oK/menU> and <UP/down> to select TONE or PULSE.
4. Press <oK/menU> to confirm; display briefly shows "Saved", then it returns to
previous menu
set the key Tone
The Key Tone is a confirmation beep when you press any key. It is set on by default, but
can be turned off, if desired.
In Idle:
1. Press <oK/menU> and <UP/down> to select Settings.
2. Press <oK/menU> and <UP/down> to select Key Tones.
3. Press <oK/menU> and <UP/down> to select On or Off.
4. Press <oK/menU> to confirm; display briefly shows "Saved", then it returns to
previous menu.
set the home area Code
In Idle:
1. Press <oK/menU> and <UP/down> to select Settings.
2. Press <oK/menU> and <UP/down> to select Home area code.
3. Use numeric keypad to enter your local 3-digit area code.
4. Press <oK/menU> to confirm; display briefly shows "Saved", then it returns to
previous menu.
using your e814
25