Table of Contents
Advertisement
TROUBLESHOOTING (continued)
Symptom and Check List (continued)
Symptoms
• No picture
The Indicating lamp
Off
• No picture
The Indicating lamp
Pulsing blue
It means that the unit is in "Power Save
mode".
• No picture
The indicating lamp
Blue
• The top of the unit and surface of the
panel heat up.
• When the VCR is in special playback
features (Fast Forward or Rewind), the
screen gets dark and cannot see the
image at all.
• Screen display size cannot be switched
correctly.
• Time information is incorrect.
• Image cannot be displayed from HDMI1,
2 or 3.
• Cannot display the image from "Photo
Input function".
• No Picture or sound is output.
(DTT mode only)
• Forgotten lock key.
(DTT mode only)
• Due to the bad reception, block noise
interferes during DTT mode.
(DTT mode only)
• The message "The receiver is looking
for new channels. Press Return button
to cancel." appears during standby
mode.
(DTT mode only)
Check list
• Check if the Power Cord is plugged into the socket fi rmly.
• Check if the Main Power is On.
• Check if all the cables of the external equipments are connected
correctly and fi rmly.
• Check if the power of the external equipments is On.
• Check if the TV/AV mode has been selected correctly.
• Check if the PC is in Power Save mode or not.
• Refer to "Power Save mode" and "When following messages appears
on the screen".
• Check if the signal cable is connected correctly and fi rmly.
• Adjust the level of Brightness and Contrast lower.
• It may happen when you use the unit for a long time. Turn off the Main
Power of the unit for a whilst. Please note that this is not malfunction.
• It could happen when the VCR is connected to Component output, such
as 480i. This is not malfunction.
• Try Composite output or S-video output and check the picture again.
• The display size is fi xed at "FULL" when the receiving signals are
720p/60Hz or 720p/50Hz.
• Adjust time by using "Time Offset" of Function Menu.
• Check if the cables are connected correctly.
• Check the output format of the equipments.
• (Please refer to "Signal Input" and "Recommended Signal List".)
• Check the connecting equipments and image format.
(Please refer to "Photo Input function".)
• It might occur because it is tuned to radio or MHEG digital teletext
channel. Return to another channel.
• Re-install channel to cancel channel lock.
• Reset the lock key.
• Check the aerial system to improve signal quality.
• If the broadc asting changes the service, the receiver starts searching
the new service during standby mode regardless of the setting. Please
note this is not malfunction.
Page
22
23
,
72
16
20
~
59
61
~
44
77
79
~
65
68
,
,
69
58
45
31
,
15
75
Advertisement
Table of Contents
