Editing - Tape Dubbing - Hitachi VT-MX935EUK Instruction Manual

EDITING — Tape Dubbing
To VIDEO IN To AUDIO IN
EJECT VIDEO LINK
VIDEO IN AUDIO IN
Controls
1
2
1 2 3
3
4 5 6
7 8 9
AUX
0
4
56
Video equipment for playback
To Scart or DECODER socket
400x DRIVE
Recording VCR
VCR Display
OR
STOP PLAY/STILL
REC /REW F.FWD/
TAPE
NAVIGATION
PROG
Connect the second video equipment to this VCR
as shown above. (Refer to the manual of second
video equipment for connection)
If the playback video source is connected to the
Scart socket, the TV must be connected to the RF
OUT terminal of this VCR.
Note: If using this VCR for playback during
dubbing or other operation, you must use the
black scart socket as a connector source.
Turn the VCR and TV on, then set the TV to the
video programme number.
Press the AUX button to display "L1", "L2" or
"L3" in the VCR's display.
Select "L3" to dub the source input via the VIDEO
IN/AUDIO IN jacks, "L2" to dub the source input
via the DECODER socket or "L1" to dub the source
input via the Scart socket on the back of the VCR.
If "L1", "L2" or "L3" is not displayed, the picture
of the TV programme being received will be
dubbed.
Insert a blank cassette into the VCR for recording,
and the cassette to be copied into the playback
VCR.