Hitachi VT-MX935EUK Instruction Manual page 54

(MENU FEATURES)
OSD ( ) or (—)
Cursor
DISP
VIDEO LINK (L1) or (L2)
Cursor
TAPE ANALYZER ( ) or (—)
Cursor
54
Press the
Screen Display setting and then press the MENU
V C R MODE
button.
O SD –
V I D E O L I N K 1 L L 2
( ): Whenever you change the mode, the new
T A P E A N A L YZER –
PROGRAM PLAY
–
AUTO –
Exit
SELECT SET MENU
(—): Any operation mode other than pressing DISP
Note: When an NTSC tape is played, no operation
mode will appear on the TV screen regardless of
the OSD on ( ) or off (—) setting.
1. Press the
V C R MODE
O SD –
2. Press the
V I D E O L I N K L1 L2
T A P E A N A L Y ZER –
P R O G R A M PLAY –
AUTO –
Exit
SELECT SET MENU
1. Press the
V C R MODE
2. Press the
O SD –
V I D E O L I N K 1 L L 2
T A P E A N A L Y ZER R –
PROGRAM PLAY –
AUTO –
Exit
SELECT SET MENU
or cursor button to change the On-
mode is automatically displayed on the TV
screen for a few seconds.
Notes:
• If the DISP button is pressed, even though
OSD "on ( )" or "off (—)" is set, the on-
screen display will appear for a few
seconds.
• When the DISP button is pressed again
before the display disappears, it will change
the VCR's display between the clock time
display and timer counter display.
button, OSD will not appear on the TV screen
even though the VCR is operated.
or cursor button to select
VIDEO LINK.
or cursor button to change the
VIDEO LINK setting and then press the MENU
button.
(L1): To record video and audio from TV, select
L1.
(L2): Your satellite/cable decoder will
automatically activate the VCR to start and
stop recording. Refer page 37.
or cursor button to select TAPE
ANALYZER.
or cursor button to change the
setting and then press the MENU button.
( ): The VCR automatically detect the type of
tape used during recording. ATRS will
appear on the TV screen when you press
REC button.
(—): ATRS function will not operate.