Cassette Tapes - Hitachi VT-MX935EUK Instruction Manual

CASSETTE TAPES

Insertion
1
O LINK
400x DRIVE
PROG
Removal
1
EJECT
VIDEO IN
SP/LP
Type of video cassette
The table below shows the recording time of
different cassettes.
SPEED SELECT SWITCH
TYPE
SP
E-30 30 minutes
E-60 60 minutes
E-120 120 minutes
E-180 180 minutes
E-240 240 minutes
• Press the SP/LP button on the remote control
handset to select the recording speed before
recording. It is set to the correct speed
automatically during play, so it is not necessary
to change it over.
• It is recommended to record in the SP mode for
higher quality picture and sound.
STOP PLAY/STILL
REC /REW F.FWD/
TAPE
NAVIGATION
EJECT VIDEO LINK
400x DRIVE
AUDIO IN
EJECT
LP
60 minutes
120 minutes
240 minutes
360 minutes
480 minutes
Only use video cassettes with the
this VCR.
Push the cassette through the door until the VCR
mechanism pulls it into the compartment.
The VCR automatically turns on and the indicator
turns on when the cassette is in place.
Press the EJECT button on the VCR or EJECT
button on the remote control.
The cassette will come partially out of the
compartment so you can pull it out.
• The indicator
ejected.
• The cassette can be ejected with operate on or
off.
REC
PROG
Remember that:
— The VCR automatically enters the playback
mode when a cassette without its safety tab is
inserted.
— If you have inserted a cassette without the
safety tab and press the REC button, "
flash in the VCR display for several seconds, and
the cassette will be ejected automatically.
— Be sure to check the safety tab before inserting
a cassette for the above reasons.
To avoid erasing a
recording
Break off the safety tab
using a screwdriver or
similar tool.
To re-record on a cassette
which has its safety tab
removed
Cover the hole with
cellophane tape.
mark in
turns off when the cassette is
" will
21