Auto Installation Function - Hitachi VT-MX935EUK Instruction Manual

AUTO INSTALLATION FUNCTION

Auto Install (Plug & Play) function
This automatically tunes all broadcast channels, sets the clock and date.
VCR
1
2
EJECT VIDEO LINK
VIDEO IN AUDIO IN
(OPERATE)
3
4
5
6
STOP PLAY/STILL
REC
/REW F.FWD/
400x DRIVE
PROG
10
TV screen
4
AUTO
MENU
TAPE
NAVIGATION
Switch on at the mains supply socket after
completely connecting all leads (as described on
pages 6 and 7).
The VCR will be in the standby mode at this stage
and the VCR display will show "– –:– –".
Press the OPERATE button.
" " will appear in the VCR display.
During this time, if your set-up include scart
connector and the TV is set to scart input, the TV
screen will display as shown.
Exit
After this process is complete, the RF output
channel will appear in the VCR display.
For example, RF output channel 35.
Switch on your TV and select an unused
programme number, i.e. one not used for BBC1,
ITV, etc. (Please consult your TV instruction
manual as your TV may have a special VCR
programme number which must be used.)
Note: This programme number will be your VCR
programme from now on.
Tune your TV (consult your TV instruction
manual) until the test pattern shown appears.
The correct tuning position is when the picture is
clear. Ensure this programme is stored in your TV.
If " " appears, press the STOP button on
the VCR or on the remote control. The RF channel
data will appear in the VCR display. Press the
PROG or
RF channel to "
press the STOP button on the VCR or on the
remote control again.
button on the VCR to change the
". To stop the RF output,