Hitachi VT-MX935EUK Instruction Manual page 33

Programming the timer without using VIDEO Plus+ programming system
Things to know before starting programming
• Turn the VCR and TV on, then set the TV to the video programme number.
• While you are programming the timer, the display on the TV screen will prompt you through the
procedure.
• Always press before a single-digit programme number, hour and minute etc.
• You can correct an error in the programme any time before the last step by pressing the 0000 button
repeatedly until the digit to be corrected changes to "–" and then enter the correct number.
• Check time and date are correct.
Controls
1
2
PDC
3
VIDEO
Plus+
AUX
TV Screen
T I M E R PR OGRA MM E
CH – – PDC
SP
Exit
0 0 0 0
MENU
~
T I M E R PR OGRA MM E
CH01
r – : – – –
SP
Exit
0 0 0 0
MENU
T I M E R PR OGRA MM E
L1
PDC
r – : – –
–
Exit
0 0 0 0 MENU
Turn the VCR and TV on, then set the TV to the
video programme number.
Press the VIDEO Plus+ button twice.
Notes:
• If the VIDEO Plus+ button is pressed when all
the programme numbers that the VCR can store
are occupied, a "FULL" indication will appear in
the VCR's display and on the TV screen.
• If you intend to use the PDC function, press the
PDC button to switch on the PDC function.
The letter PDC will appear next to the channel
number on the screen. For further information
on PDC, see page 65.
F UL L
7
=DLY/WKL
Exit
Select the TV programme number to be recorded.
For example, press
Note: If you enter a TV programme number that
you have not preset in the VCR, you cannot
proceed to the next setting.
To record video and audio signals from external
equipment via the Scart socket on the back of the
VCR, press the AUX button so that "L1" is
displayed on the TV screen in place of a
programme number.
To record via the DECODER socket on the back of
the VCR, press the AUX button again to display
"L2".
for TV channel 4.
33