Preparation; Remote Control Batteries Installation; Handling The Remote Contorl; Caution When Moving The Main Unit - Hitachi 32LD9700U User Manual

PREPARATION

Remote Control Batteries Installation

This remote control operates on 2 "AA" batteries.
1. Open the battery compartment
cover
Slide open the battery
compartment cover on the
backside of the remote control in
the direction of an arrow.
2. Install the batteries
Install 2 "AA" batteries (included) making
sure the polarities match the indication
inside the compartment.
3. Close the battery compartment cover.
To close the battery compartment
cover, slide the cover in the
direction of an arrow till it clicks
shut.
CAUTION
It could cause corrosion or battery leakage and may result in physical injury
and/or property damage including fi re.
Never mix used and new batteries in the device.
Replace all the batteries in a device at the same time.
Remove the batteries if the remote control is not going to be used for an extended period of time.
To avoid possible failure, read the following instructions and handle the
remote control properly.
Do not drop or cause impact to the remote control.
Do not spill water or any liquid on the remote control.
Do not place the remote control on a wet object.
Do not place the remote control under the direct sunlight or near sources of excessive heat.

Caution When Moving the Main Unit

As this product is heavy, whenever it is moved, two people are required to transport it safely.
When transferring the unit, hold the unit by using the handgrips at the backside of the panel. (See the fi gures below
for details.)
32" models:
Handgrips
12
Handling the Remote Control
Use the remote control within about 5m from
front of the unit's remote-control sensor and
within 30 degrees on both sides.
Within 30 degrees
About 3m
37" models:
Handgrips
Within 30
degrees
About 3m
About 5m