Hitachi 32LD9700U User Manual page 72

TROUBLESHOOTING (continued)
Symptom and Check List (continued)
Symptoms
No picture
The Indicating lamp → Off
No picture
The Indicating lamp → Orange
It means that the unit is in "Power Save
mode".
No picture
The indicating lamp → Green
The top of the unit and surface of the
panel heat up.
Image cannot be displayed in the correct
position.
When the VCR is in special playback
features (Fast Forward or Rewind), the
screen gets dark and cannot see the
image at all.
The images are not displayed on sub
pictures in "Multi Picture mode"
Screen display size cannot be switched
correctly.
Cannot be displayed the image from
HDMI 1 or 2.
Check list
Check if the Power Cord is plugged into the socket fi rmly.
Check if the Main Power is ON.
Check if all the cables of the external equipments are connected
correctly and fi rmly.
Check if the power of the external equipments is ON.
Check if the TV/AV mode has been selected correctly.
Check if the PC is in Power Save mode or not.
Refer to "Power Save mode" and "When following messages appears on
the screen".
Check if the signal cable is connected correctly and fi rmly.
Adjust the level of Brightness, Contrast and Back Light lower.
It may happen when you use the unit for long hours. Turn off the Main
Power of the unit for a while. Please note that this is not malfunction.
Press button to check if the input signal of the displayed image is
compatible with the specifi cation of the television.
It could happen when the VCR is connected to Component output, such
as 480i. This is not malfunction.
Try Composite output or S-video output and check the picture again.
There are some combinations of input signals that the images are not
displayed on sub pictures.
Please check the Table of "2-Picture" and "4-picture/2-picture(1080i)" for
details.
The display size is fi xed at "FULL" when the receiving signals are
1080i/60Hz, 1080i/50Hz, 720p/60Hz, or 720p/50Hz.
Check the signal status by pressing the
control.
Check if the cables are connected correctly.
Check the output format of the equipments.
(Please refer to "Connecting Procedure" and "Recommended Signal
List".)
button on the remote
Page
19 20
,
68
15 18
~
73 75
,
28 73
, ,
75
57 59
~
76
52 53
~
73 75
~
71