Pre-Tuning Of Built-In Tv Tuner - Hitachi VT-FX950EUKN Instruction Manual

PRE-TUNING OF BUILT-IN TV TUNER

Controls
1
2
3
PROG /
MENU
1 2 3
4 5 6
7 8 9
0
4
12
TV Screen
1 2 AUTO 3
REV I EW CHANNEL
4 VCR 5
MODE CLOCK
MENU
AUTO
=
MENU
2
The VCR should display "– –:– –" in it's LCD panel
after the main supply is connected.
Turn on the TV and the VCR, then tune the TV to
the video programme number.
If you connect the VCR and TV using a 21-pin Scart
connector lead, select the 21-pin Scart input of the
TV.
Press the MENU button.
The menu, as illustrated, appears on the TV
screen.
Exit
=
Press the 2 button.
The display, as illustrated, appears on the TV
screen and "
The VCR will automatically store channels
received in your area. It takes about 3 minutes.
Exit
The following stations are stored in programme
numbers 01 — 05 automatically.
01 BBC1
02 BBC2
03 ITV
04 CH4 (or S4C)
05 CH5
Note: If the station does not transmit a signal
which identifies itself, the station name will not
appear.
You can watch the progress on the TV's screen —
when the channel numbers stop changing, pre-
tuning is complete.
Press the PROG
channels you can receive.
Note: If no channels have been set or a clear
picture does not appear, check the aerial or Scart
connection.
Note: When the pre-tuning of a channel is
completed, the current time may appear in the
VCR's display. This is because the auto clock
setting function has operated and the VCR's clock
has been set automatically. (See page 18 for
details.)
" appears in the VCR display.
/ button to check the