Hitachi VT-FX950EUKN Instruction Manual page 11

VCR
6
7
PROG
8
9
Safety Tab
TV
Press the PLAY/STILL button.
Note: If the VCR displays "
button on the remote control or on the VCR. The RF
channel data will appear in VCR display. Press the
PROG button to change the RF channel to
To stop the RF output, press STOP button on remote
control or on the VCR again.
If you cannot tune your TV correctly to the test
signal, or there is distortion in the signal, it may be
necessary to change the VCR's RF out channel. In
this case, press the PROG select button (
on the VCR to change the VCR's RF channel. Then
re-tune your TV. If the test signal has not improved,
continue to change the VCR's RF channel and re-
tune your TV each time, until a clear test pattern
received.
VCR's RF channel will change as follows:
CH 22
Press the PLAY/STILL button again. The test
pattern will disappear and the VCR will now come
out of the standby mode into the operate mode.
You should now be able to playback a prerecorded
cassette.
Insert the cassette carefully (see page 20 for
CASSETTE TAPES). If the safety tab is removed,
then playback will start immediately, if not press the
PLAY/STILL button and the picture will appear on
the screen.
" press the STOP
CH
CH
or
)
CH 35 CH 69
.
11