Front USB and Power Switch Assembly
Description
Front USB and power switch assembly
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Remove the fan
5.
Disconnect the cables from the following system board connectors:
●
FRONT USB (yellow)
●
PB/LED (black)
●
FRONT AUD (blue)
6.
Press in on the two tabs on each side of the assembly (1).
7.
Rotate the top of the assembly downward, and then pull the assembly out through the hole in the
front of the chassis (2) while guiding the wires through the hole in the chassis.
To reinstall the front USB and power switch, reverse the removal procedure.
40
Chapter 4 Removal and Replacement Procedures
(Preparation for Disassembly on page
(Access Panel on page
(Front Bezel on page
Front Fan/Baffle on page
16).
17).
38.
Spare part number
682432-001
15).