Table of Contents
Advertisement
6.
Install the Powered USB expansion card into the PCI Express x1 socket on the riser card. Move
the card toward the rear of the chassis so that the bracket on the card is aligned with the open
slot on the rear of the chassis (1). Press the card straight down into the expansion socket on the
riser card (2).
Figure 4-3
7.
The cable included with the card has a single connector on one end and dual connectors on the
other end. All three connectors are keyed to ensure proper connection. Connect the single end
of the cable to the rear of the card (1). Connect the green connector on the other end of the
cable to the green USB connector on the system board (2). Connect the black cable connector
to the black USB connector on the system board (3).
NOTE:
the green cable from the card to either row.
Figure 4-4
28
Chapter 4 Removal and Replacement Procedures
Installing the Powered USB Expansion Card in the Riser Card
The green USB connector on the system board has two rows of pins. You can attach
Connecting the 12-volt Powered USB Cable
Advertisement
Table of Contents
