Intellitouch 2500S Serial Controller - Elo TouchSystems Elo IntelliTouch Manual

Elo touchsystem owner manual monitor elo intellitouch
Table of Contents

Advertisement

IntelliTouch 2500S Serial Controller

Electrical
Supply Voltage and
Current
Interface
Baud Rate
Operating Modes
Touch Resolution
Conversion Time
Reliability
Environments
Temperature
Humidity
Operating Altitude
Shock and Vibration
ESD
Flammability
Physical Characteristics
Construction
Dimensions
+5 Vdc, nominal (+4.75 to +5.25 Vdc).
60 mA, typical at +5 Vdc. Average power dissipation is 0.3 W, typical.
Supply must be capable of sourcing 100 mA, minimum.
Total noise and ripple requirement must be less than 100 mV (p-p) for
frequencies below 1 MHz, and less than 50 mV (p-p) for frequencies above 1
MHz.
EIA 232E (Serial RS-232), DCE configuration. 8 Data Bits, 1 Stop Bit, No
Parity, Full Duplex.
Hardware handshaking: RTS/CTS
DSR is pulled HIGH (>+3V) by the 2500S when connected and powered. DTR
is ignored
9600 (default) and 19200
Full IntelliTouch SmartSet or E281A-4002 protocols, jumper selectable.
Initial/ Stream/ Untouch/ Z-axis Enable Modes.
4096x4096, size independent, 255 levels of Z (pressure).
Approximately 10.4 ms per coordinate report.
MTBF greater than 300,000 hours per MIL-HDBK-217-F2 (using the parts
stress calculation method for ground benign environment with an ambient
temperature of 25 C).
Operating:0°C to 65°C.
Storage:-25°C to 85°C.
Operating:10% to 90% RH, non-condensing.
Storage:10% to 90% RH, non-condensing.
10,000 feet.
Three axis since wave, 50 Hz to 2kHz, 1 G, 2 minutes/Octave with dwell on
resonances.
Per EN 6100-4-2 1995: Level 4. Contact discharge 8kV, air discharge 15kV.
The printed circuit board substrate is rated 94V0. All plastic components, such a
headers and connectors, are also rated 94V0.
Four-layer surface-mount design with internal ground plane for EMI
suppression.
Total Width: 2.36 inches (59.94 mm), including connectors
Total Length: 3.30 inches (83.82 mm)
Total height: 0.40 inches (10.16 mm)
All mounting holes are plated through for chassis ground connection. Refer to
the drawings at the end of this document.
B-71

Advertisement

Table of Contents
loading

This manual is also suitable for:

Intellitouch seriesSecuretouch series

Table of Contents

Save PDF