5.4 Checking the nominal voltage
2 5
ATTENTION!
The nominal voltage indicated on the type plate and the mains voltage
must correspond.
1
The adaptation to the local mains voltage has to be done at the
terminal strip 3 and the transformer 6 in the control cabinet.
–
Screw off the cover 1 at the control cabinet.
–
Loosen screws 2 and 5 and remove the guard 4.
–
Check the arrangement of the connections to terminal strip 3 and
transformer 6.
(see circuit diagram, sheet 2 and 3).
–
If necessary, change the connections according to the local mains
voltage.
–
Put the guard 4 on again and screw it on with the screws 2 and 5.
–
Put the cover 1 on the control cabinet again and screw on.
bl = blue / sw = black / bn = brown
4
2
6
5
4
3
17