Special Diagnostics - Gerber GS750 Plus User Manual

SPECIAL DIAGNOSTICS

In addition to the self-check tests that are part of the power-up
sequence, the GS750
diagnostics. The steps to access these diagnostics and their
functions are outlined below.
To access special diagnostics
1. Hold down the RESET key during power-up.
2. When a steady tone sounds, release the RESET key. There
will be two beeps followed by three beeps as the self-check
tests are completed. Then the lights above the RUN CONT
and RUN SINGLE keys will alternate. These alternating lights
mean that RESET was held at power-up and that a special
diagnostic can now be performed.
3. Access one of the special diagnostics described next by
pressing the slew key noted in the description.
Note: Only one special diagnostic can be accessed at each
power-up sequence. To access another diagnostic, turn the
plotter power off and then on again (as described above).
plus
plotter can perform other special
45