Pounce Wheel Holder; Aligned Holes - Gerber GS750 Plus User Manual

plus
26 GS750
5. Push down on the upper end of the pen until the point just
touches the table surface.
6. Use the Allen wrench to tighten the set screw near the tip of
the pen. Do not over-tighten the set screw or the pen could be
crushed.
7. Replace the cap in the barrel.

Pounce Wheel Holder

Pouncing is a technique used to create an outline for a sign that
will later be hand-painted. Pouncing can also be used to align
vinyl letters on a large job. The pounce wheel is designed to
pounce (perforate) holes either perfectly aligned or off-center to
the direction of travel.
CAUTION: The pounce wheel may be used only in tangential
knife mode. Pouncing in swivel knife mode will tear the
paper.

ALIGNED HOLES

There are two keyway slots on the barrel of the pounce wheel
holder. The standard keyway aligns the pounce with the drum
axes. Use this position to produce small holes in lightweight
paper or for light dusting applications.