Operation; Power Up - Gerber GS750 Plus User Manual

OPERATION

Power Up

When the GS750
1. A short beep sounds, the Power light comes on, and the RUN
CONT, RUN SING and SWIVEL KNIFE lights blink.
2. As the GS750
RUN and SWIVEL KNIFE keys flash, and an additional beep
sounds.
3. When the self-check is complete, the lights blink and a beep
sounds.
4. The plotter goes off-line in tangential knife mode. Only the
Power light remains on. This is the initial setting at power-up.
Note: Rapid, continuous beeping and flashing lights may signal a
self-check error. See the "Error Conditions" section for more
information.
plus
is turned on, the following sequence occurs:
plus
performs self-check tests, the lights over the
37