Materials And Tools; Materials - Gerber GS750 Plus User Manual

MATERIALS AND TOOLS

Materials

The GS750
plotters. Gerber vinyl products in high performance or
intermediate grades are available in translucent, reflective, or
metallic finishes and come in a wide range of colors. Also
available are direct-cut screenprint stencil, ruby photo film, paint
masking material, rubber sandblast stencil material and heat
transfer materials. Consult your Gerber distributor for further
information about available materials, colors and prices. Always
insist on Gerber authorized materials for highest quality results.
To load material
CAUTION: It is recommended that you load material
without a tool in the carriage to prevent damaging the
knife blade.
1. Slide the roll of material to be used onto the material support
bar. Pull the end of the material away from and over the top
of the roll holder toward the plotter and feed directly onto the
rubber drum.
CAUTION: When power is on, the carriage spindle must
be moved only by using the slew keys. Attempts to
manually move the plotter drum, rotate or force the tool
up or down will damage the plotter.
CAUTION: While power is off, center the carriage by
gently pushing toward the center of its travel. Take care
to move the carriage slowly and firmly by gripping the
right end of the carriage housing, not by gripping the
carriage spindle.
plus
uses the same plotting materials as all Gerber
17