Install Plotter On Stand; Mount Tool Rack; Mount Roll Support Bars - Gerber GS750 Plus User Manual

5. Insert a screw, with a washer, into each of the holes at each
side of the plotter stand base.
6. Verify that the alignment between the plotter stand base and
the stand assembly is correct, then tighten the screws.
7. Push a tube cap in each open end of the plotter stand base.
8. Install the feet in the bottom of the stand base. If installing the
Caster Option, refer to the instructions packed with the
casters.
9. Return the plotter stand to its upright position.

Install Plotter on Stand

Lift the plotter onto the stand assembly. Be sure the two metal
tabs which project from the top of each leg assembly are inside
the end plates of the plotter. Install a Phillips screw through each
tab into the plotter assembly.

Mount Tool Rack

Mount the tool rack on the back of the GS750
panel by installing the screws through the holes in the tool rack
and plotter.

Mount Roll Support Bars

1. To install the roll support bars behind the vanity panel, align
the ends of the bottom roll support bar with the lowest position
in the hole on each leg assembly.
2. Insert the ends of the bar into the top of the holes and slide
the ends firmly down to the bottom of the holes. Repeat this
procedure with the other two roll support bars.
Installation 9
plus
above the power