Run Cont Key - Gerber GS750 Plus User Manual

plus
42 GS750
Single Plot Exercise
1. Turn on the GS750
manually, install the pen holder, and set the tool force to .5.
2. Using the slew keys, position the carriage spindle
approximately 1" from the front edge of the plotting paper.
Also, be sure that there are several inches of paper extending
past the carriage spindle and to the left of the plotter.
3. Send a plot file to the GS750
4. Press the RUN SINGLE key to plot the test exercise.
RUN CONTINUOUS KEY
Use RUN CONT to access the continuous plotting mode and
RUN
maximize the plotter's productivity.
CONT
To plot in continuous mode
1. Select either swivel or tangential knife mode by pressing the
SWIVEL KNIFE key. When swivel knife mode is selected, the
light above the SWIVEL KNIFE key is on.
2. Press RUN CONT. The light above the RUN CONT key
comes on and the GS750
without waiting for user prompting between the jobs.
The GS750
plotted. When one job finishes plotting, the next job waiting in the
queue begins immediately.
When all jobs in the queue are plotted, the GS750
line until the operator presses either RUN key or the RESET key
to return to off-line status.
plus
. Load plotting paper, test the pen
plus
plus
plots one job after the other
plus
creates a waiting list, or queue, of jobs to be
plotter.
plus
remains on-