7.3 Cutter-blade position
3
2
36
1
Caution: danger of injury
Turn off the main switch.
The position of the cutter blades may only be checked and adjusted
with the machine switched off.
Regulation and inspection
When the thread cutter system is in its normal position, the thread
puller blade 5 should overlap the counter-blade 4 by 1 mm.
Adjustment
–
Move the thread lever to the up position.
5
–
Undo screws 1 and adjust the position of the cutter blades by
altering the relative positions of the push rods 2 and 3.
4
–
Retighten screws 1.
5
4