Table of Contents
Advertisement
6.4.2
Altering global parameters
28
Parameter 29:
Needle feed
Maximum run
Input:
0 ...120
Parameter 38:
Start delay light barrier
Input:
0 ...2000
Parameter 39:
Differential feed
Maximum run
Input:
0 ...120
Parameter 40:
Basic value needle feed
Input:
0 ...120
Parameter 41:
Basic value needle feed on / off
Input:
0 / 1
Parameter 42:
Basic value differential bottom feed
Input:
0 ...120
Parameter 43:
Basic value differential bottom feed on/ off
Input:
0 / 1
Parameter 45:
Number of stitches until the table blowing is
switched on
Input:
0 ...400
Parameter 46:
Duration of the stacker impulse
Input:
0 ...2000
Parameter 47:
Time of the stacker movement
Input:
0 ...2000
Parameter 48:
Speed limitation
Input:
max. 6500
Parameter 49:
Speed during the warp separation
Input:
500...5000
Parameter 50:
Number of stitches until the thread tension is opened
(seam end)
Input:
0....50
Parameter 56:
Seam programming on/ off
On = 1 Determine the seam sequences in the
current program
Off = 0 Create the next free program with seams
Input:
0 / 1
Parameter 58:
Display of the software version
Parameter 59:
Number of stitches how long the seam chain is
sucked (seam beginning)
Input:
0 ...50
Parameter 65:
Thread tension lift
Input:
0 ...50
Parameter 79:
Soft start after "Stop in the seam"
Input:
0 ...500
Parameter 80:
Reset daily piece counter
Advertisement
Chapters
Table of Contents
