Disassembly and Assembly
Disassembling the Engine
3.2.3
This section describes disassembling the engine, including the engine controller board (PWB-A)
and power supply board (PWB-E).
3.2.3.1 Engine Controller Board (PWB-A) Removal
1.
Remove thevideocontroller board (C125 MAIN board). (Refer to Section 3.2.l.l.)
2.
Open the top cover. Remove the imaging cartridge. Cover the imaging cartridge to protect it
from light or place it in a dark area.
Remove the control panel. (Refer to Section 3.2.1.3.)
3.
4.
Remove the paper cover.
Remove the right cover. (Refer to Section 3.2.2.1.)
5.
6.
board (PWB-A).
7.
Remove 4 CC screws (M3 x 6) on the engine controller board (PWB-A).
8.
Remove the engine controller board (PWB-A).
c c
c c
Figure 3-10. Removing the Engine Controller Board (PWB-A)
Board
X 6)
6)
Rev. A