4.1 ADJUSTMENT
This section describes the adjustment procedure for the EPL-5600 and ActicxLaser 1600. This
adjustment must be performed after every servicing operation, especially when any component or
part is replaod
4.1.1 Print Position Adjustment
You can adjust the vertical print position on a sheet of paper by turning the image synchronizing
volume control on the engine amtroller board
is replaced, be sure to adjust the print position following the procedure below.
1. Set Language Setting to ENGLISH in Language Setting Mode,
2. Printa STATUS SHEET using SelecType.
3. Check that the registration gap between the leading edge of paper and the printing of a
horizontal line is the correct value as follows.
S'I'ATUSSHEETpage tbr EPL-5600 (A4paper) : 19.1 k 2.5 mm(O.75 t O.10inch)
STATUS SHEET page for ActionLaser NXXI(letterpaper) : 143 + 25 mm(056f O.10inch)
If not, adjust the print position as described in the next few steps.
.
4. Turn the printer power off.
.
upper unit, open the paper cover, and remove the one screw samring the ~td
panel.
Rev. A
Leading Ed!&
EPSON
Figure 4-1. Print Position Adjustment
Figure 4-2. Opening the Upper Unit, Paper Cover, and
Removing 1 Screw
19.1 m (0.75 inch)
14.3 Ilnl (0.56 inch)
/
status
4-1