Changing The Bobbins - DURKOPP ADLER 745-34-2 Operating Instructions Manual

2.8

Changing the bobbins

22
1 2 3
ATTENTION!
Switch the main switch off before changing the bobbin.
–
After a certain number of seams the hook thread quantity on the
bobbin is used up.
–
With the remaining thread monitor switched on the message
"Empty bobbin" appears in the display.
–
The pocket opening in progress is finished with the help of the
thread reserve in the reserve grooves of the bobbin hub.
–
After corner incision the workpiece is moved out or stacked.
–
The transport carriages runs to its rear end position.
It can be restarted after the bobbin change only.
Removing the empty bobbin
–
Switch the main switch off.
–
Swing the folding station aside.
–
Lift the fabric sliding sheet and swing it away to the left and to the
right (see chapter 2.2).
–
Lift the upper part of the bobbin case in the area 2.
Thereby the bobbin case retainer 3 is lifted, too.
–
Remove the upper part of the bobbin case together with the empty
bobbin.
–
Remove the empty bobbin from the upper part of the bobbin case.
4