Table of Contents
Advertisement
Puller
11.7 Changing the carrier roller
Fig. 42: Changing the carrier roller
(1) - Nut
Important
When exchanging a Vulkollan carrier roller for a steel carrier roller, you need
to readjust the lower end position of the carrier roller stroke ( p. 50).
To change the carrier roller:
1. Remove the nut (1).
2. Lock the axle (2) with a screw driver.
Carrier rollers for different areas of application
Material
Vulkollan
Vulkollan
Steel
Steel
Steel
* If assembled accordingly, the asymmetric carrier roller can effect a different position
relative to the seam / folding of the material.
The asymmetric carrier roller can also be used on 2-needle machines.
Service Instructions 171/173 - 00.0 - 01/2020
CAUTION: Left-handed thread!
Width
9 mm
16 mm
9 mm
15 mm
15 mm
①
②
(2) - Axle
assembled as standard
asymmetrical*
1mm pyramid-tooth cut
1mm pyramid-tooth cut
2 mm saw-tooth cut
53
Advertisement
Table of Contents
