2-3 Specifying the Angle Unit and Display
Format
Before performing a calculation for the fi rst time, you should use the Setup screen to specify
the angle unit and display format.
k Setting the Angle Unit
1. On the Setup screen, highlight "Angle".
2. Press the function key for the angle unit you want to specify, then press J.
• {Deg}/{Rad}/{Gra} ... {degrees}/{radians}/{grads}
• The relationship between degrees, grads, and radians is shown below.
k Setting the Display Format
1. On the Setup screen, highlight "Display".
2. Press the function key for the item you want to set, then press J.
• {Fix}/{Sci}/{Norm}/{Eng} ... {fi xed number of decimal places specifi cation}/
{number of signifi cant digits specifi cation}/{normal display}/{Engineering mode}
To specify the number of decimal places ( Fix)
Example
To specify two decimal places
1(Fix)cw
Press the number key that corresponds to the
number of decimal places you want to specify
n
(
= 0 to 9).
# Displayed values are rounded off to the
number of decimal places you specify.
Specifying the Angle Unit and Display Format
360° = 2 π radians = 400 grads
90° = π/2 radians = 100 grads
2-3-1
20070201
[SET UP]-
[Angle]
[SET UP]-
[Display]