Terminal Settings - Casio DT-800RF Supported Equipment Manual

Terminal Setup
Connecting the Cradle
The terminal download requires a serial connection between the terminal and the PC
through a cradle. Connect the serial load cable from a serial port on the PC to the
communications port of the terminal cradle or to a Casio terminal.
In preparation for this download perform the following:
•
Make sure you have copied the LMWIN utility to any directory on your PC.
•
Connect the selected serial port on the PC to the cradle with a null modem cable. Use
COM Port 1.
•
Verify that the cradle is powered on.
•
If you are using a cradle, configure the cradle baud rate to 115200.
•
Set the dip switches on the bottom of the cradle. There are ten switches. The up
position of a switch is the on position. The settings for the ten switches are shown
below to set the cradle baud rate to 115200.
Switch
Setting
When using a cable, the baud rate to select is also 115200.

Terminal Settings

Command Mode Boot
On the portable terminal, power the terminal
sequence as shown in the following table.
Terminal Model & Keypad
DT-800RF
The System Menu is displayed.
1. Select
2. Enter the IP Address, Netmask, Gateway, Domain, etc.
2-10
1 2 3
On Off Off
Command Mode Boot Sequences
Following Power
1. EXECUTE AP
2. SET MODE
3. DATE/TIME
4. TRANSMIT
5. CALIBRATION
6. VERSION
7. SS UTILITY
and then
7: SS Utility 1: Environment.
4 5 6
Off On Off
, then boot the terminal using the key
OFF
OFF
Key Sequence
Press the and keys,
FNC 0
then press and release the
then release the
FNC
SYSTEM MENU
Supported Equipment Manual
7 8 9
On On On
key,
PWR
and keys.
0
• March, 2006
10
On