Getting Started; Crossbar Mounting Bracket Installation - Casablanca Panama Owner's Manual

Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where
you wish to place your Casablanca fan, an ap-
proved ceiling fixture outlet box must be installed
and wired.
WARNING!
To reduce the risk of fire, electrical shock, or
personal injury, mount to outlet box marked
"Acceptable Fan Support of 22.7 kg (50
lbs.) or less" using the mounting hardware
provided with the outlet box.

CroSSBar MoUNTING BraCkeT INSTaLLaTIoN

Ceiling Hardware (not to scale)
Crossbar Mounting Bracket
Note: after removing the old fixture, check the outlet
box to insure that it is supported by a joist or beam
across its upper surface. If not, a 2 x4 stud must be
installed.
Step 1a� Remove the knockout plug in the center
of the outlet box or drill a
screw to pass through. Then drill a
hole into the joist or beam to a depth of 3 inches.
Step 1b� Route the outlet box wires through the
keyhole slot of the crossbar mounting bracket as
shown. Attach the crossbar mounting bracket to the
outlet box with the screws provided, making sure
the outlet box wires are not pinched by the washer.
CAUTION:
To reduce the risk of personal injury, use only
the mounting hardware provided with the
approved outlet box to install the crossbar
mounting bracket.
WARNING!
Support directly to building structure only.
CAUTION:
Damp Location rated fans required a Ground
Fault Interrupter(GFI). use a weather-proof
outlet box, properly connect ground wires,
and use only under a weather-proof structure
faN INSTaLLaTIoN

GeTTING STarTeD

1" x 8-32 Roundhead Screw and Washer (2)
2
/ -inch hole for the lag
1
2
/ -inch guide
1
4
P
anama
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either
the circuit breaker or fuse box), lower the old fixture
and disconnect the wiring. Check the ceiling fixture
outlet box to be sure it is marked "Approved for
Ceiling Fan Mounting." If it is not, a new box must
be installed.
Note: The weight of this fan is 24 to 26 pounds,
depending on model.
Lag Screw and Washer (1)
Roundhead Screw
" x 8-32
1
/
4
Joist
Ceiling-Fan-
Approved
Wiring Box
Crossbar
Mounting Bracket
Green Ground Wire
1" x 8-32
Roundhead Screw
®
Wire Nut (4)
(2)
Ceiling Wiring
Ridge side down
Washer
7