Casablanca Panama Owner's Manual page 14

®
WALL CONTROL AND HARDWARE (not to scale)
W-85
Switch Mounting
Wall Control
Screws (2)
warNING!
To avoid possible electrical shock, make cer-
tain that electricity is turned off at the circuit
breaker or fuse box before attempting any in-
stallation or repair procedure
CAUTION! NOT turning the power OFF at the
circuit breaker or fuse box may cause damage to
the electronics within the wall control and or the PC
board on the fan.
Before installing the W-85 wall control you will need
to check and see if you will need to change the
bezel on the front of the wall control from WHITE to
ALMOND. If you are going to use white, skip these
steps and go to wall control installation starting on
page 15. The bezel can be changed at any time
before or after installation. The wall control does
not need to be uninstalled to replace the bezel.
W-85 Wall Control Bezel replacement installation
as follows
Step 17a� Locate the four (4) tabs holding the bezel to
the front of the switch, then press in on each tab one
at a time, removing the bezel as shown in Figure #1.
Step 17b� Locate the rubber key pad attached to
the four (4) locating pins as shown in Figure #2 and
remove rubber key pad from the WHITE bezel, also
as shown in Figure #2.
14
3
W-85 CoNtroL INStaLLatIoN
Switch Bezels
(1) White
(1) Almond
LOCATING
HOLES(4)
White Wall Almond Wall
Plate(1) Plate(1)
Figure #1
WHITE
BEZEL
PINS
RUBBER KEY
PAD
(4) Wire Cap
Wall Plate
Screws
(2) White
(2) Almond
BEZEL
BEZEL
TABS
LOCATING
PINS (4)
figure #2