DURKOPP ADLER 381 Installation Instructions Manual page 20

Programming steps:
1. Calling up programming mode
-
Turn off main switch.
-
Operate the key "P" and hold it operated.
-
Turn on main switch.
The display will show "C-0000".
-
Release the key "P".
2. Changing over to the technician level
-
Enter code number "1907" by the digital keys "1...0".
-
Operate the key "E".
The controller will change over to the technician level ".
The display will show the parameter no. "F-100".
-
If a wrong code number is entered, the display will show "C-0000 Info F1".
Enter again.
3. Programming reference position
-
Enter parameter number "170" by the digital keys "1...0".
-
Operate the key "E".
The display swill show the parameter "F-170" together with the code designation
"Sr1" (Service routine 1).
The LED above the key "F" will be blinking.
-
Operate the key "F".
The display will show "Position 0".
-
Turn the handwheel until the reference position is attained (Needle point flush
with the throat plate level).
-
Operate the key "P".
The position set will be memorised.
4. Programming position 1
-
Enter parameter no. "171" by the digital keys "1...0".
-
Operate the key "E".
The display will show the parameter "F-171" together with the code designation
"Sr2" (Service routine 2).
The LED above the key "F" will be blinking.
-
Operate the key "F".
The display will show "Position 1" and the respective number of increments.
Pos1 = 151 , Pos1a = 200
-
Turn the handwheel until the 1st position is attained.
5. Programming 2nd position
-
Operate the key "E".
The display will show "Position 2" and the respective number of increments.
Pos2 = 460 , Pos2a = 510
-
Turn the handwheel until the 2nd position is attained.
20