DURKOPP ADLER 381 Installation Instructions Manual page 21

6. Parameter setting
Following parameters must be set before putting the machine into operation.
(see also the parameter sheet 9800 130012 PB05)
–
F-111 n2
–
F-115 n6
–
F-119 nST
–
F-190 iFA
–
FSA
F-191
–
F-202 br1
7. Leaving correction mode
-
Operate the key "P".
8. Memorizing the setting
-
Tread the pedal briefly forwards.
-
Tread the pedal completely backwards.
The threads will be cut. The sewing feet will be lifted.
The corrected setting will be memorised.
-
The sewing machine is ready to operate.
= 2500 upper limit of the maximum speed
= 250 Softstart speed
= 2 Speed graduation slightly progressive
= 300 Engagement angle FA
= 100 Disengagement delay of the thread tension release
= 5 Braking effect
NOTE !
For terminating the correction process it is absolutely
necessary to sew a short distance. This will finally
memorise the modified setting.
If no sewing is done, the setting will be lost after turning off
the main switch.
21