Operating Controls - Elektra Beckum TopLine PK 255 Operating Instructions Manual

Operating controls

On/off switch with emergency stop
· To switch ON = press green button.
· To switch OFF = press red button or cover of on/
off switch.
3
An undervoltage relay trips in the event of a
voltage failure, to prevent a restarting of the
saw when the power is restored. To start the
saw again after a power failure press the
green button.
To prevent unauthorized use the switch can be
blocked with a padlock.
Handwheel for blade tilt setting
The saw blade can be tilted steplessly between 0°
and 45°.
The centre of motion is at saw table level, so the
depth of cut remains the same, regardless of the
bevel angle.
2 5
PK 255
2 5
2 5
Ratchet lock lever
The set bevel angle can be locked with a ratchet
lock lever, so it does not change during sawing.
3
There are several ratchet lock levers on the
saw. If the swivelling range is not sufficient,
the lever position can be shifted:
pull lever up, turn and let engage again.
Handwheel for setting the depth of cut
The depth of cut can be adjusted by turning the
handwheel.
2 5
3
To compensate for possible play in the blade
height setting mechanism, always raise the
blade to the desired position.
2.5