Turning Power On And Off; Display Angle Adjustment - Alpine CDA-7873R Owner's Manual

Basic
POWER
g DN
Basic Operation
About Demonstration
This unit is equipped a Demonstration function.
Soon after resetting the unit or after turning the
unit on the first time, the demonstration starts
automatically.
To cancel the demonstration, refer to
"Demonstration" on page 10.

Turning Power On and Off

1
Press the POWER button to turn on the unit.
NOTE
The unit can be turned on by pressing any other button
except the eject c button.
The volume level gradually increases to the previous
level you were listening to before the unit was turned
off. Press and hold the POWER button for at least 3
seconds to turn off the unit.
NOTE
The very first time the power is turned on, the volume
will start from level 12, the BBE will be on in the tuner
mode.
6
-EN
TUNE MODE/BBE
f UP
SETUP ANGLE 89

Display Angle Adjustment

The movable display may be adjusted to 3
different angles depending upon user preference.
1
Press the ANGLE 89 button to adjust the angle
of the movable display.
NOTES
The display will close a half minute after the ignition
key is turned to the OFF position.
The adjusted angle of the display is stored in memory.
There is no need to re-adjust the angle when the power
is turned back on.
CAUTION
Keep hands (or any other object) away from the display
while it is opening or closing to avoid damage or injury.
The back of the movable display will get very warm
under normal operating conditions. This is not a
malfunction. Do not touch.
c
Movable display