Installation - Alpine CDA-7873R Owner's Manual

Installation

Caution
When you install this unit in your car, do not remove
the Detachable Front Panel.
If the Detachable Front Panel is removed during
installation, you might press too hard and warp the
metal plate that holds it in place.
1
Bracket
Dashboard
Mounting sleeve
(Included)
CDA-7876RB/CDA-7873R/TDA-7588RB/TDA-7587R
Slide mounting sleeve from main unit (see
"Removal" on this page). Slide the mounting
sleeve into the dashboard.
2
Metal Mounting Strap
Hex Nut (M5)
CDA-7876RB/CDA-7873R/TDA-7588RB/TDA-7587R
When your vehicle has the Bracket, mount the
long hex bolt onto the rear panel of the CDA-
7876RB/CDA-7873R/TDA-7588RB/TDA-7587R
and put the Rubber Cap on the hex bolt. If your
vehicle does not have the Mounting Support,
reinforce the head unit with the metal mounting
strap (not supplied). Connect all the leads of the
CDA-7876RB/CDA-7873R/TDA-7588RB/TDA-
7587R according to details described in the
CONNECTION section.
NOTE
For the screw * , provide a proper screw to the chassis
installing location.
Metal plate
Detachable
Front panel
Rubber Cap
(Included)
Hex Bolt
(Included)
Screw
Bolt Stud
3
Slide the CDA-7876RB/CDA-7873R/TDA-
7588RB/TDA-7587R into the dashboard. When
the unit is in place, make sure the locking pins
are fully seated in the down position. This can be
done by pressing firmly in on the unit while
pushing the locking pin down with a small
screwdriver. This ensures that the unit is properly
locked and will not accidentally come out from
the dashboard. Install the Detachable Front
Panel.
Lock pin
Removal
1 Remove the detachable front panel.
2 Use a small screwdriver (or similar tool) to push
the locking pins to the "up" position (see above
drawing). As each pin is unlocked, gently pull
out on the unit to make sure it does not re-lock
before unlocking the second pin.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
CDA-7876RB/CDA-7873R/
TDA-7588RB/TDA-7587R
Front frame
Screws (M5 8)
(Included)
Mounting Bracket
39
-EN