Adjusting The Built-In Crossover; Switching The Display Modes; Cda-7876Rb/Tda-7588Rb Only; Changing The Audio Level Display Pattern - Alpine CDA-7873R Owner's Manual

Adjusting the built-in Crossover

You can change High Pass Filter, Low Pass Filter,
Phase on this unit, so that you can create your
favourite sound effects.
1
Press the X-OVER button repeatedly to select
the desired parameter.
OFF HPF
2
Press the DN g or f UP button to select
the disired setting.
1. HPF (Setting the High Pass Filter):
OFF 80Hz
Outputs all frequencies higher than that selected
according to your preference.
2. LPF (Setting the Low Pass Filter):
OFF 80Hz
Outputs all frequencies lower than that selected
according to your preference.
(Only available when using the subwoofer output
from this unit.)
NOTES
If you turn the battery power OFF, all settings return
to factory default.
If HPF, LPF, Bass Control and Treble Control are all
set to ON, depending on the Bass Control and Treble
Control settings, you may not be able to reinforce the
sound effect.
Except when the HPF and LPF is turned OFF, the
subwoofer is in monaural mode.
When the subwoofer is set to OFF, LPF mode and
change of phase does not work.
If no buttons are pressed within 5 seconds, the display
for setup menu disappears while an ordinary menu
appears on the display.
LPF
120Hz 160Hz
120Hz 160Hz

Switching the Display Modes

CDA-7876RB/TDA-7588RB only

You can select the display pattern mode from
three display patterns. You can also deactivate the
display.
1
Press the DISP (DISPLAY) button to select the
desired Display pattern mode.
Each press changes the display patterns.
Pattern1 Pattern2
Changing the Audio Level Display
Pattern

CDA-7873R/TDA-7587R only

You can select the disired display pattern mode
from three Audio Level Display Patterns. You can
also deactivate the display.
1
Press DISP button to switch the display pattern.
Pattern 1 Pattern 2
Basic
Pattern3 Display OFF
Pattern 3 Display OFF
13
-EN