Display Auto Dark (Dark); Oscillator (Osc) - RME Audio Micstasy User Manual

11.13 Display Auto Dark (dArk)

Default: Off
Available settings: On, Off
Displays and LEDs on the front panel can be switched off by activating the option Display Auto
Dark. Only the decimal points from the 8 numerical LED displays will be lit. Such a mode is
useful e. g. on stage.
Dimming takes place 10 seconds after the function has been activated. At the same time all
control elements are momentarily locked, the device is therefore protected against unintentional
changes. The combination Save-Recall (Setup menu) is not affected. All other keys can also be
activated temporarily by keeping them pushed for a short time.
Note: dArk is available since firmware version 2.1.

11.14 Oscillator (oSC)

Default: Off
Available settings: On, Off
With bigger setups it can be difficult to follow the exact routing and signal path. The signal gen-
erator built into the Micstasy simplifies this task significantly. Choose oscillator (oSC) and acti-
vate this option by pushing one of the 8 Select keys. A square wave signal of approximately 180
Hz at a level of -30.1 dBFS will be generated and displayed immediately. Push the same button
again to switch the oscillator off.
With activated test tone the numerical display of the corresponding channel will show 'to' (test
oscillator) instead of the Gain value.
Note: oSC is available since firmware version 2.1.
User's Guide Micstasy © RME
24