Directed Electronics AutoCommand 25622 Owner's Installation Manual page 43

Table of Contents

Remote Start Test

Once steps 1-5 have been completed, the operation of the system

can be tested.

Ensure that the two 30-amp fuses are in the relay harness PINK

wire fuse holders. Make sure that the vehicle is in park with the

emergency brake on and the hood closed. Pulse the activation

input wire 2 times to initiate the remote start function. The

parking lights should flash to confirm the remote start command

has been received, The accessories and ignition should turn on

followed by the starter cranking and the vehicle engine running

(this may take a moment to initiate). Pulse the activation input

wire 2 times again and the engine will stop running. (See

Programming System settings section for 1 press remote start

operation)

This completes the Remote Start testing, if all functions do not

work correctly check your wiring against the manual and verify all

connections. If you still experience problems contact Directed

Technical Support at 1-800-477-1382.

Table of Contents