Table of Contents
Advertisement
H2 Harness - 6 pin connector
___
GREEN
H H 2 2 / / 1 1
___
BLUE
H H 2 2 / / 2 2
___
RED/BLACK
H H 2 2 / / 3 3
___
YELLOW/GREEN
H H 2 2 / / 4 4
___
H H 2 2 / / 5 5
BROWN
___
H H 2 2 / / 6 6
YELLOW/BROWN
Pin #
Color
H2/1
Green
H2/2
Blue
H2/3
Red/Black
H2/4
Yellow/Green
H2/5
Brown
H2/6
Yellow/Brown
© 2006 Directed Electronics
Note
Use this wire if the vehicle fails to start correctly in
voltage mode
Negative output to horn circuit. If your horn is posi-
tive, use a relay.
Used on diesel engines only. Connects to wait-to-start
wire
Ignition output. Connect this wire to the ignition input
of an aftermarket alarm system.
Retained accessory shutdown or factory rearm output.
Connect this wire to factory arm wire if equiped or to
door trigger wire if your vehicle's accessories stay on
after remote start finishes cycle.
Headlight output. Connect this wire to headlight wire
in car. If headlights are positive, a relay is required.
Tachometer input
(-) 400mA horn output
(-) wait-to-start input
(+) ignition output
(-) 400mA RAP Output
(-) 400mA headlight output
9
Advertisement
Table of Contents
