Directed Electronics AutoCommand 25622 Owner's Installation Manual page 20

If the GREEN wire is being used for ign2 an additional relay (not
provided) is required for a 2nd accessory. Refer to the diagram
below.
WHITE (+) 30A OUTPUT TO
ACCESSORY CIRCUIT
Now that the accessories have been located, find the suspected
starter wire according to the web information. Leave the black
lead of your tester on ground and place the red lead of your multi-
meter on this wire. The multimeter should read 0 volts in all key
positions except the crank position. In the crank position your
multimeter should read 12 volts, and will go to 0 volts when the
starter disengages.
© 2006 Directed Electronics
+12 VDC CONSTANT (FUSED 20A)
TO ACCESSORY
+12 VDC CONSTANT (FUSED 20A)
ACCESSORY RELAY
(NOT PROVIDED)
87
GROUND
85
86 87A
30
TO ACCESSORY
2 nd ACCESSORY RELAY
(NOT PROVIDED)
87
GROUND
86 85
87A
30
TO 2 nd ACCESSORY
17