Configure Ipx Routing; Enable Ipx Rip; Enable Sap; Configure Static Routes - Cabletron Systems SmartSwitch Router User's Reference Manual

• 802.2: 802.2 encapsulation method used within Novell IPX environments
Configure Ethernet II encapsulation.
Configure 802.3 SNAP encapsulation.
Configure 802.3 IPX encapsulation.
Configure 802.2 IPX encapsulation.

Configure IPX Routing

By default, IPX routing is enabled on the SSR.

Enable IPX RIP

IPX RIP is enabled by default on the SSR. You must first create an IPX interface or assign
an IPX interface to a VLAN before RIP will start learning routes.

Enable SAP

IPX SAP is enabled by default on the SSR. You must first create an IPX interface or assign
an IPX interface to a VLAN before SAP will start learning services.

Configure Static Routes

In a Novell NetWare network, the SSR uses RIP to determine the best paths for routing
IPX. However, you can add static RIP routes to RIP routing table to explicitly specify a
route.
To add a static RIP route, enter the following command in Configure mode:
Add a static RIP route.
SmartSwitch Router User Reference Manual
Chapter 9: IPX Routing Configuration Guide
interface create ipx
output-mac-encapsulation ethernet_II
interface create ipx
output-mac-encapsulation ethernet_snap
interface create ipx
output-mac-encapsulation
ethernet_802.3
interface create ipx
output-mac-encapsulation
ethernet_802.2_ipx
<networkaddr>
ipx add route
<nextrouter or network node> <metric> <ticks>
<Interface Name>
<Interface Name>
<Interface Name>
<Interface Name>
155