Table of Contents
Advertisement
3: IrCZ interface
4: USB interface
5: Bluetooth interface
Bluetooth in m=5 is only for model equipped with Bluetooth interface.
Setting the Cable auto selection mode: n=29
● Sets the enabling/disabling of the Cable auto selection mode. When this code is set to enable, if a
cable is plugged at the time of power-on of the printer, Interface mode will be automatically set to
the cable.
m=0: disabled
1: enabled
Image generation speed setting: n=31
●Image generation speed can be set. When set to 'Fast,' data can be printed faster than usual. However, there
are some differences as follows.
1) DEL code function is not available while page mode is specified.
2) Justification (full-just) of alignment command (ESC a) is not available.
3) When horizontal tab (HT) and alignment command (ESC a) are specified at the same time, the
horizontal tab (HT) is not available.
4) When absolute position specification command (ESC $) and alignment command (ESC a) are
specified at the same time, the absolute position specification command (ESC $) is not
available.
m=0: Normal
1: Fast
Setting the printing of printer's internal setting: n=255
● Prints out the current state of internal setting values of the printer. After printing out, the printer is automatically
turned OFF.
m=0: Prints the printer's internal setting
● Be sure to write the setting value in the flash memory with ESC~SS after setting categories using this
command. The set values become effective at the next power-ON.
52
Advertisement
Table of Contents
