Installing A New Paper Roll - Royal Alpha 710ML User Manual

Chapter 9 Maintenance and Options

Installing a New Paper Roll

As you use the cash register, you will need to replace the paper roll. Your
cash register has a thermal printer that prints receipts for the customer or
a journal tape. Use 2¼ inch (57.5 mm) wide standard thermal register
paper. Do not use bond paper because the register does not use a ribbon
or ink for printing.
Do not manually pull the receipt paper. Always use the Feed key to
remove or advance the paper. Do not use sharp or pointed instruments in
the printer area. This can seriously damage the printer.
To install the paper roll
1 Open the Journal Compartment Cover. Remove the Journal
2 Remove the Journal
3 Grab the small handle
4 Lay the end of the paper across the
89
Caution
Compartment Cover and set aside. Remove the tape on the black
Journal Tape spindle inside the printer compartment of the cash register.
Takeup spindle. Place
the paper roll in the
little round area at the
bottom of the
compartment. Make
sure the paper feeds
out from the bottom of
the roll, towards the
front of the cash
register.
on the right of the print roller. Push
the little handle towards the back of
the cash register and raise the roller
bar up.
printer as shown. Move the print
roller down onto the paper and snap
into place. Make sure both sides are
snapped down.
Press the Feed key until the paper catches and moves through the
printer.
Handle
Alpha 710ML User's Guide