Installing Tailgate And Splashguard; Installing Roll Bar And Cover; Installing Tow Bar - Burley Nomad Owner's Instruction And Safety Manual

Installing Tailgate and Splashguard

Nomad:
1. Loop tie-down straps over corners of side panels and
join male buckle sections on straps to female buckle
sections inside trailer.
2. To accommodate different sizes of cargo, tighten or
loosen the webbing straps as needed.

Installing Roll Bar and Cover

Nomad:
1. Place cover over side panels, with "Nomad" logo at trailer
front.
FIGURE 3
2. Slip one roll bar knob through a grommet on
cover.
FIGURE 3
3. Slide roll bar through casing in divider, and match roll bar
end with its corresponding hole on side rail.
4. Thread roll bar knob through side rail, and tighten.
5. Repeat for knob on other side.
6. Loop O-rings on cover over trailer frame tube ends.
Make sure cover extends over top of side panels.

Installing Tow Bar

1. Slide tow bar through both tow bar mounts on left side.
2. Match rear tow bar hole with rear mount hole.
3. Insert the retaining pin through both holes, and lock
retaining hoop securely.
6
B U R L E Y N O M A D A N D F L A T B E D O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L
FIGURE 3 & PHOTO 8
PHOTO 8
PHOTO 9 & PHOTO 10
Trailer
Rear
PHOTO 8
Tailgate
Trailer Frame
FIGURE 3: NOMAD
Tow Bar Mounts
PHOTO 9: NOMAD TOW BAR INSTALLATION
Buckle
Webbing Strap
Side Rail
Roll Bar
Cover Grommet
Roll Bar Knob
O-Ring
Webbing Strap
Splashguard
Retaining Pin
Trailer Front