HP Kayak XA-s 02xx Manual page 12

Installing a Hard
Disk Drive
Before Installing an
IDE Hard Disk
Before Installing a
SCSI Hard Disk
NOTE
HP Kayak XA-s 02xx PC Workstation - Installing Accessories In Your HP Desktop PC Workstation
Installing Mass Storage Devices
This PC Workstation has integrated Dual Ultra ATA-33 IDE controllers
and, on selected models, an Ultra SCSI interface board.
The Dual Ultra ATA-33 IDE controllers support up to four fast
•
(33 MB per second) IDE devices.
On selected models, the Ultra SCSI 16-bit interface board, installed
•
in a PCI slot, supports up to 13 external SCSI devices and
automatically switches to non-Ultra or standard mode.
Refer to the drive's installation guide to see if you must set jumpers or
if there is a special installation procedure to follow.
If you are installing an additional SCSI drive, you should assign an
unused SCSI address to this accessory. SCSI addresses range from 0 to
7 for Ultra narrow 8-bit SCSI and from 0 to 15 for Ultra wide 16-bit SCSI.
SCSI address 0 is used by the first SCSI hard disk drive and SCSI
address 7 is reserved for the integrated SCSI controller (the default for
narrow and wide SCSI devices).
You do not need to select a SCSI address for Plug and Play SCSI hard
disks (SCSI hard disks that support the SCAM protocol).
You should assign an unused SCSI address to the second SCSI hard
disk drive (for example, SCSI address 1).
The SCSI address is usually configured with jumpers on the SCSI hard
disk drive. Refer to the installation guide supplied with the drive for
information on selecting a SCSI address.
Some internal SCSI disk drives may have termination resistors that
must be removed or disabled before installation in your computer.
Refer to the drive's installation guide for more details and to see if
there is a special installation procedure to follow.
12 English