Align the back of the cover
with the inner back edge of
the PC Workstation's case.
Intrusion Monitor
HP Kayak XA-s 02xx PC Workstation - Installing Accessories In Your HP Desktop PC Workstation
Removing and Replacing the Cover
Replacing the Cover
1 Ensure that you have installed all your accessories and that all
internal cables are properly connected and safely routed.
2 Lower the cover completely onto the computer (aligning the back of
the cover with the inner back edge of the PC Workstation's case),
and firmly slide it backwards into place. Ensure that the retaining
latches click into position.
Ensure that the retaining
latches on either side of
the PC Workstation's
case click into position.
3 If required, lock the cover using the key provided.
4 Reconnect all the power cables.
Your PC Workstation is equipped with an intrusion monitor, which is
located on the front of the PC Workstation, behind the Hardware
Control Panel. It is designed to detect whether your PC Workstation
has been opened since the last time it was used.
If your PC Workstation has been opened, it is assumed that the
•
system configuration has changed and a full start-up check is carried
out.
If your PC Workstation has not been opened, it is assumed that the
•
system configuration has not changed and a reduced start-up check
is carried out.
4
English