Canon JX510P User Manual page 91

Hide thumbs Also See for JX510P:
Table of Contents

Advertisement

Available languages

Available languages

MEMORY FULL
Cause
The fax's memory is full because it has
received too many documents, or a
very long or detailed document.
The fax's memory is full because you
either tried to send or copy too many
pages at once, or you tried to send or
copy a very long or detailed document,
using memory sending.
The total maximum recording time of
30 minutes has been reached
(JX510P only).
NO INK
Cause
Ink has run out.
NO OGM
Cause
The outgoing message has not been
recorded.
NO TEL #
Cause
The one-touch speed dialing button or
coded speed dialing code you entered
has not been registered.
REC'D IN MEMORY
Cause
The fax received the document in
memory because paper or ink ran out,
a paper jam occurred, or the incorrect
FINE Cartridge was installed.
The fax receives documents in memory
because the <AUTO PRINT> setting is
set to <OFF>.
RECOMEND NEW CRT
Cause
Ink is low.
REMOVE DOCUMENT
Cause
The document is set while printing.
88
Troubleshooting
Print and delete any documents stored in memory (see page 40). Then start
again.
Free up space in the fax's memory by printing or deleting any documents in
memory you no longer need (see page 40).
If multiple pages are loaded, separate the pages into smaller stacks. If not, try
sending the document by direct sending (see page 23).
Listen to your telephone messages and delete any unnecessary messages.
Alternatively, erase all telephone messages stored in the fax memory (see
page 46).
Replace the FINE Cartridge (see page 62).
Record an outgoing message (see page 42).
Register the one-touch speed dialing button or coded speed dialing code (see
page 17).
Load paper in the Rear Tray (see your setup sheet or page 21), replace the
FINE Cartridge (see page 62) or clear the paper jam (see page 72).
Print any documents stored in memory (see page 40).
Set the <AUTO PRINT> setting to <ON>. This enables to print received faxes
automatically (see page 37).
Replace the FINE Cartridge (see page 62).
Remove the document. Press [Stop/Reset] and try printing again.
Action
Action
Action
Action
Action
Action
Action

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jx210p

Table of Contents