Getting Ready; Placing The Rk-300 On A Stand; If Using The Ksc-48 Stand - Roland VIMA RK-300 Owner's Manual

Getting Ready

CAUTION
Do not grasp the jack panel cover when lifting the RK-300
keyboard unit.
fig.JackCoverCaution.eps

Placing the RK-300 on a Stand

If you place the RK-300 on a stand, you must use the special stand KSC-48 (sold separately) or KS-G8 (sold separately).
When placing the RK-300 on the KSC-48 or KS-G8, place it in the position shown below.
Using the RK-300 with any other stand may produce an unstable situation, possibly causing the instrument to fall or overturn, and
resulting in injury or damage.
For details on how to assemble the stand, refer to the owner's manual that accompanied the stand.

If Using the KSC-48 Stand

Stand Assembly
At first, assemble the entire stand in a temporary fashion,
without really tightening the screws. Then, after checking
the overall alignment of the boards (and gently shifting
certain parts where necessary), go around and tightly fasten
each of the screws.
1.
Attach the side board (right) for the right sides to
the speaker box.
Use screws to temporarily fasten these parts together.
26
Jack panel cover
If you need to transport the RK-300 keyboard unit, remove
the jack panel cover, and hold the bottom of the unit when
lifting it.
fig.JackCoverRemove.eps
Loosen
Grasp
here
2.
Attach the side board (left) for the left sides to the
speaker box.
Use screws to temporarily fasten these parts together.
3.
After you've temporarily fastened the screws, place
the stand upright, and securely tighten screws to
fasten the speaker box and side boards.
Loosen