Using The Unit Safely - Roland VIMA RK-300 Owner's Manual

USING THE UNIT SAFELY

USING THE UNIT SAFELY
Used for instructions intended to alert
the user to the risk of death or severe
injury
improperly.
Used for instructions intended to alert
the user to the risk of injury or material
damage should the unit be used
improperly.
* Material damage refers to damage or
other adverse effects caused with
respect to the home and all its
furnishings, as well to domestic
animals or pets.
Safety grounding connection
001-50
Connect mains plug of this model to a mains socket
outlet with a protective earthing connection.
.................................................................................................................................
Do not disassemble or modify
002a
Do not open or perform any internal modifications on
the unit.
.................................................................................................................................
Do not repair or replace parts
003
Do not attempt to repair the unit, or replace parts
within it (except when this manual provides specific
instructions directing you to do so).
Refer all servicing to your retailer, the nearest Roland
Service Center, or an authorized Roland distributor, as
listed on the "Information" page.
.................................................................................................................................
Never install the unit in any of the following locations
004
• Subject to temperature extremes (e.g., direct
sunlight in an enclosed vehicle, near a heating
duct, on top of heat-generating equipment); or are
• Damp (e.g., baths, washrooms, on wet floors); or
are
• Exposed to steam or smoke; or are
• Subject to salt exposure; or are
• Humid; or are
• Exposed to rain; or are
• Dusty or sandy; or are
• Subject to high levels of vibration and shakiness.
.................................................................................................................................
14
should the unit be
The symbol alerts the user to important instructions
or warnings.The specific meaning of the symbol is
determined by the design contained within the
used
triangle. In the case of the symbol at left, it is used for
general cautions, warnings, or alerts to danger.
The symbol alerts the user to items that must never
be carried out (are forbidden). The specific thing that
must not be done is indicated by the design contained
within the circle. In the case of the symbol at left, it
means that the unit must never be disassembled.
●
The symbol alerts the user to things that must be
carried out. The specific thing that must be done is
indicated by the design contained within the circle. In
the case of the symbol at left, it means that the power-
cord plug must be unplugged from the outlet.
Use only a stand that is recommended
005
This unit should be used only with a stand that is
recommended by Roland.
.................................................................................................................................
Do not place in an unstable location
006
When using the unit with a stand recommended by
Roland, the stand must be carefully placed so it is
level and sure to remain stable. If not using a stand,
you still need to make sure that any location you
choose for placing the unit provides a level surface
that will properly support the unit, and keep it from
wobbling.
.................................................................................................................................
Connect the power cord to an outlet of the correct
voltage
008a
The unit should be connected to a power supply only
of the type described in the operating instructions, or
as marked on the rear side of unit.
.................................................................................................................................
Use only the included power cord
008e
You must use only the power cord included with the
device. Do not use the included power cord with any
other device.
.................................................................................................................................
Do not bend the power cord or place heavy objects on
it
009
Do not excessively twist or bend the power cord, nor
place heavy objects on it. Doing so can damage the
cord, producing severed elements and short circuits.
Damaged cords are fire and shock hazards!
.................................................................................................................................